KABELIS SKRĘTKA SOLARIX CAT.6A STP LSOH 500m

Solarix installation cable SXKD-6A-STP-LSOH is a high quality four-pair cable category 6A, which is designed for use in very demanding applications - especially for high-speed 10GBaseT protocol operation. This cable seamlessly meets the requirements specified in the international standards ANSI/TIA/EIA 568 and ISO/IEC 11801 for Category 6A and Class EA wiring respectively. The cable conductors are made of high quality AWG 23 copper wire with polyethylene insulation and are tested up to 500 MHz bandwidth. The individual pairs are individually shielded with aluminium foil, the sheath type is LSOH. The cable colour is grey. The SXKD-6A-STP-LSOH cable is marked with a continuous meter gauge of 1 m and is supplied on a high-strength wooden spool on which all necessary product information is provided, including barcodes, production batch, description and the most important technical parameters (e.g. NVP in the form of a QR code). Solarix LSOH installation cables meet the following standards: A) Acidity of gases produced during combustion IEC 60754-2: Test on gases evolved during combustion of electric cables - Part 2: Determination of degree of acidity of gases evolved during the combustion of materials taken from electric cables by measuring pH and conductivity EN 50267-2-2: Common test methods for cables under fire conditions - Tests on gases evolved during combustion of materials taken from cables - Part 2-2: Procedures - Determination of the degree of acidity of gases during combustion of cable materials by measuring pH and conductivity EN 50267-2-3: Common test methods for cables under fire conditions - Tests for gases evolved during combustion of cable materials - Part 2-3: Procedures - Determination of the degree of acidity of gases during combustion of cable materials by determining the weighted average pH and conductivity of composite materials (B) Smoke density IEC 61034-2: Measurement of smoke density of cables burning under defined conditions - Part 2: Test procedure and requirements IEC 61034-2: Measurement of smoke density of cables burning under defined conditions - Part 2: Test procedure and requirements (This standard has superseded EN 50268-2) (C) Flame retardancy/flame spread of single insulated cables IEC 60332-1-2: Tests on electric and optical fibre cables under fire conditions - Part 1-2: Test for vertical flame propagation for a single insulated wire or cable - Procedure for 1 kW pre-mixed flame EN 60332-1-2: Tests on electrical and optical fibre cables under fire conditions - Part 1-2: Test for vertical flame propagation for a single insulated wire or cable - Procedure for 1 kW mixed flame (superseded by this standard EN 50265-2-1 -Category: CAT6A -Supported protocols [?] : 10GBaseT -Shielding: foil around each pair -Bandwidth [?] : 500 MHz -Conductor [?] : 0, 565 mm AWG 23 copper wire -Insulation [?] : 1, 4 mm polyethylene -Sheath [?] : LSOH -Colour: grey -Cable diameter: 7, 3 mm -Weight: 54 kg/km -NVP [?] : 75 % -Propagation delay [?] : 500 ns/100 m -Delay skew [?] : 20 ns/100m -Storage temperature: -20°C to 60°C -Operating temperature: -20°C to 60°C -Installation temperature: 0°C to 50°C