Visos prekės
Krepšelis
Tuščias
Prekių
Krepšelis
Prisijunkite, kad pamatytumėte krepšelio turinį
Prisijungti
4.5
4.5
Į krepšelį
The ULTENIC Pooleco 10 is a cordless robot designed for automatic cleaning of pool bottoms. The device is equipped with two powerful motors, a 5200 mAh battery, and an operating system that allows for up to 90 minutes of continuous operation. A single charge, which takes about 2.5 hours, allows it to clean an area of up to 80 m². The model is designed for above-ground, in-ground, and indoor pools, and its cordless design eliminates the problem of tangled cords. Operation is controlled with a single button, so getting the device ready for use takes just a moment.
The ULTENIC Pooleco 10 robot uses two independent motors to effectively remove debris from the bottom of the pool. Thanks to its dual suction system, the device efficiently collects leaves, insects, sand, dust, and other debris that settles on the surface. This solution helps keep the pool clean with less effort and reduces the need for manual debris removal.
The high-capacity 5200 mAh battery allows for uninterrupted operation for up to 90 minutes. This is enough time to thoroughly clean a surface area of up to 80 m² without having to pause operation or recharge the device. Charging takes about 2.5 hours, and a simple LED indicator shows the charging status. A red light indicates a low battery or that charging is in progress, while a green light means the battery is fully charged.
The absence of cords allows the robot to move freely across the pool floor without the risk of tangling or limiting its operating range. Thanks to its compact size, the device is easy to carry, store, and set up for operation. Simply place the robot in the water and press the start button to begin the automatic cleaning cycle.
The ULTENIC Pooleco 10 is designed to work on surfaces made of mosaic, plaster, fiberglass, and vinyl materials. The device works with above-ground, in-ground, and indoor pools, and its design allows for effective operation on surfaces with a slope of up to 10 degrees. The maximum recommended pool depth is 3 meters. It’s worth noting that this model is designed exclusively for cleaning the pool floor and is not intended for cleaning walls, steps, or the waterline.
The robot’s designers focused on intuitive operation and minimizing the number of steps required to start the device. The use of a float with a cord makes it easy to remove the robot from the water, and additional brushes and spare wheels help extend the equipment’s service life. The compact housing, measuring 32.39 × 32.08 × 16.58 cm, makes it easy to store the device even outside the summer season.
| Manufacturer | ULTENIC |
|---|---|
| Model | Pooleco 10 |
| Device type | cordless pool bottom cleaning robot |
| Battery | 5200 mAh |
| Operating time | up to 90 minutes |
| Charging time | approximately 2.5 hours |
| Maximum cleaning area | up to 80 m² |
| Number of motors | 2 |
| Maximum surface slope | 10° |
| Maximum pool depth | 3 m |
| Supported surfaces | mosaic, plaster, fiberglass, vinyl |
| Dimensions | 32.39 × 32.08 × 16.58 cm |
| Charge status indicator | LED |
| Intended use | cleaning the pool bottom |
| Unsupported functions | cleaning walls, steps, and the waterline |
2-5 d. d.
2-5 d. d.
2-5 d. d.
1-5 d. d.
1-5 d. d.
1-5 d. d.
2-5 d. d.
2-5 d. d.
2-4 d. d.
2-5 d. d.
1-4 d. d.
7-10 d. d.
10-11 d. d.
7-10 d. d.
5.0
4 d. d.
4-7 d. d.
2-5 d. d.
7-10 d. d.
Pagalba
Kontaktai
Atsiliepimai
Verslui
Varlė
LPExpress paštomate rugpjūčio 24 d.
Omniva paštomate rugpjūčio 24 d.
DPD kurjeriu rugpjūčio 24 d.
