xTool P3 Conveyor Rail

xTool P3 Conveyor Rail is a 69 cm support rail that extends the working length of your P3 setup when used with the Intelligent Conveyor Feeder. Add one or more rails to stabilize long sheets and stacked batches while the feeder advances material automatically. Full-length rollers on the rail keep the feed smooth and prevent slip for consistent results. With rails, you can go far beyond the base 1,500 mm pass-through and support truly large-scale jobs. Key Features

• 69 cm rail segment for the P3 feeder, add as needed
• Lets you extend projects to virtually any length
• Full-roller design helps keep material from slipping
• Complements the P3’s suspended rail design (no extra table up to 1,500 mm)
• Recommended when unsupported edges exceed ~300 mm
• Simple way to stabilize panels, boards, and batch runs

What it does

Conveyor Rail is an add-on support piece for the xTool P3’s Intelligent Conveyor Feeder. Each section measures 69 cm and can be added in series to back up long materials as the feeder advances them through the machine. This turns the P3 into a practical tool for extra-long signage, furniture panels, and high-volume runs where stability over distance is key.

Stability you can see

The rail uses full-length rollers so stock glides forward without chatter. That continuous contact reduces the chance of skew and slip, helping the camera-guided alignment and automated feeding do their best work over long passes.

Scale up, without a massive table

Out of the box, the P3’s suspended rail design lets you process materials up to about 1,500 mm without building a separate support table. When your job runs longer than that, adding Conveyor Rails lets you extend support “as long as you like” by chaining rails together.

Setup tips

For flat, consistent feeding, avoid large overhangs: if the unsupported portions on both sides of your workpiece exceed roughly 300 mm, add rails. Set the spacing between the left and right rails to match the material width so pressure is even and deformation is minimized.

Where it fits in

Conveyor Rail is purpose-built for the xTool P3 Intelligent Conveyor Feeder. It doesn’t change the machine’s cutting specs; it simply gives your long or heavy stock the backup it needs so the feeder can move it cleanly over distance. For oversized jobs, add more rails to maintain support from start to finish.