The Ultracur3D Cleaner removes any uncured photopolymer resin from printed parts and is compatible with a wide variety of resins, incl. most resins of the Ultracur3D portfolio. Highlights:

Quick and efficient solution for removing any uncured photopolymer resin from printed parts
Compatible with a wide variety of resins, incl. most resins of the Ultracur3D portfolio
Water rinseable
No damage to ‘green’ part or cured resins when used as recommended

Ultracur3D Resin Cleaner

The Ultracur3D Cleaner removes any uncured photopolymer resin from printed parts and is compatible with a wide variety of resins, incl. most resins of the Ultracur3D portfolio.

Cleaning Procedure

1. Immerse the part in an agitated bath of Ultracur3D Cleaner for a maximum of 10 minutes. Typical cleaning time is recommended between 5 to 8 minutes. Some require cleaning below 5 minutes.
2. Rinse with 2-propanol for additional 1-3 minutes
3. 2-propanol can be blown off with pressured air or parts can be dried at ambient temperature. For accelerated drying heat the part for approximately 10 minutes at 60 °C (140 °F)

Ultracur3D Cleaner is non-harmful, non-flammable at room temperature and can be heated up to 50 °C to increase cleaning efficiency. This cleaner is suitable for industrial part washing and cleaning equipment.

Ultracur3D® Cleaner can normally be used until it contains about 10-20% of resin, or until the cleaning performance is noticeably reduced. After this, it should be disposed according to local regulations.

Material Properties

Liquid Color: Blue
pH value: 7 (25 °C)
Melting Point: > 50 °
Boiling Point: > 100 °C
Vapour Pressure: 0.017 hPa (20 °C)
Density: 1.09 g/cm3 (20 °C)
Viscosity @ 20 °C: mPa·s (cP) 5

Pastebėjote klaidą prekės aprašyme ar nuotraukų galerijoje? Praneškite mums.

Skaityti daugiau

Skaityti mažiau